Cisco Catalyst 3650 Series User Manual

rep admin vlan
To configure a Resilient Ethernet Protocol (REP) administrative VLAN for REP to transmit hardware flood
layer (HFL) messages, use the rep admin vlan command in global configuration mode. To return to the
default configuration with VLAN 1 as the administrative VLAN, use the no form of this command.
rep admin vlan vlan-id
no rep admin vlan
Syntax Description
The 48-bit static MAC address.
vlan-id
Command Default
The default value of the administrative VLAN is VLAN 1.
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introducedCisco IOS XE Denali 16.2.2
Usage Guidelines
The range of the REP administrative VLAN is from 2 to 4094.
If you do not configure an administrative VLAN, the default VLAN is VLAN 1. The default VLAN 1 is
always configured. There can be only one administrative VLAN on a router and on a segment.
You can verify your settings by entering the show interfaces rep detail privileged EXEC command.
Examples
The following example shows how to configure VLAN 100 as the REP administrative VLAN:
Device(config)# rep admin vlan 100
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
326
rep admin vlan

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)