Cisco Catalyst 3650 Series

clear autonomic
To clear or reset autonomic information, use the clear autonomic command in privileged EXEC configuration
mode.
clear autonomic {device| neighbor neighbor's UDI| registrar accepted-device device UDI}
Syntax Description
Clears or resets device information.device
Clears or resets neighbor information.
neighbor udi
Clears public key stored for each enrolled device
registrar accepted-device udi
Command Default
No default behavior or values.
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
The clear autonomic device command clears or resets all device-specific autonomic information, including
the information obtained in the bootstrapping process. The clear autonomic neighbor command clears the
neighbor-related information learned during the neighbor discovery. If no neighbor is specified, the command
clears the entire neighbor database. The clear registrar accepted-device clears the public key stored for each
device enrolled by the registrar.
Examples
To clear all device-specific autonomic information:
Device #clear autonomic device
% invoke syslog_an_delete_host: vrf cisco_autonomic
discriminator
Device#
Jul 15 05:55:53.987: %SYS-5-CONFIG_I: Configured from console by console
Jul 15 05:55:53.988: %PKI-4-NOCONFIGAUTOSAVE: Configuration was modified. Issue "write
memory" to save new IOS PKI configuration
Jul 15 05:55:53.990: %AN-6-ACP_DIKE_TO_NBR_REMOVED: Removed DIKE on ACP Tunnel100000 from
Device (Addr FD08:2EEF:C2EE:0:E865:493B:ACFB:7) to Neighbor (Addr
FD08:2EEF:C2EE:0:E865:493B:ACFB:5) connected on interface GigabitEthernet1/0/3
Jul 15 05:55:54.006: %AN-6-ACP_CHANNEL_TO_NBR_REMOVED: Removed ACP Tunnel100000 from Device
(Addr FD08:2EEF:C2EE:0:E865:493B:ACFB:7) to Neighbor (Addr FD08:2EEF:C2EE:0:E865:493B:ACFB:5)
connected on interface GigabitEthernet1/0/3
Jul 15 05:55:54.015: %SYS-5-CONFIG_I: Configured from console by console
Jul 15 05:55:54.016: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback100000, changed
state to down
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
890
clear autonomic