Cisco Catalyst 3650 Series

Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
You must enable DHCP snooping on the interface before entering this command. Use the ip dhcp snooping
command to enable DHCP snooping.
Examples
This example shows how to specify the database URL using TFTP:
Device(config)# ip dhcp snooping database tftp://10.90.90.90/snooping-rp2
This example shows how to specify the amount of time before writing DHCP snooping entries to an external
server:
Device(config)# ip dhcp snooping database write-delay 15
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
766
ip dhcp snooping database