vmps retry
To configure the per-server retry count for the VLAN Query Protocol (VQP) client, use the vmps retry
command in global configuration mode. Use the no form of this command to return to the default setting.
vmps retry count
no vmps retry
Syntax Description
Number of attempts to contact the VLAN Membership Policy Server (VMPS) by the
client before querying the next server in the list. The range is 1 to 10.
count
Command Default
The default retry count is 3.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This example shows how to set the retry count to 7:
Device(config)# vmps retry 7
You can verify your setting by entering the show vmps privileged EXEC command and examining information
in the Server Retry Count row.
Related Commands
DescriptionCommand
Displays the VQP version, reconfirmation interval, retry count, VMPS IP
addresses, and the current and primary servers.
show vmps
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1063
vmps retry