Cisco Catalyst 3650 Series User Manual

clear errdisable interface vlan
To reenable a VLAN that was error-disabled, use the clear errdisable interface command in privileged EXEC
mode.
clear errdisable interface interface-id vlan [vlan-list]
Syntax Description
Specifies an interface.
interface-id
(Optional) Specifies a list of VLANs to be reenabled. If a VLAN list is
not specified, then all VLANs are reenabled.
vlan list
Command Default
No default behavior or values.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
You can reenable a port by using the shutdown and no shutdown interface configuration commands, or you
can clear error-disable for VLANs by using the clear errdisable interface command.
Examples
This example shows how to reenable all VLANs that were error-disabled on Gigabit Ethernet port 4/0/2:
Device# clear errdisable interface gigabitethernet4/0/2 vlan
Related Commands
DescriptionCommand
Enables error-disabled detection for a specific cause
or all causes.
errdisable detect cause
Configures the recovery mechanism variables.errdisable recovery
Displays error-disabled detection status.show errdisable detect
Displays error-disabled recovery timer information.show errdisable recovery
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
725
clear errdisable interface vlan

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)