Gi3/0/7 auto off 0.0 n/a n/a 30.0
Gi3/0/8 auto off 0.0 n/a n/a 30.0
Gi3/0/9 auto off 0.0 n/a n/a 30.0
Gi3/0/10 auto off 0.0 n/a n/a 30.0
Gi3/0/11 auto off 0.0 n/a n/a 30.0
Gi3/0/12 auto off 0.0 n/a n/a 30.0
<output truncated>
This is an example of output from the show power inline interface-id command on a switch port:
Device> show power inline gigabitethernet1/0/1
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi1/0/1 auto off 0.0 n/a n/a 30.0
This is an example of output from the show power inline module switch-number command on stack member
3. The table that follows describes the output fields.
Device> show power inline module 3
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
3 865.0 864.0 1.0
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi3/0/1 auto power-deny 4.0 n/a n/a 15.4
Gi3/0/2 auto off 0.0 n/a n/a 15.4
Gi3/0/3 auto off 0.0 n/a n/a 15.4
Gi3/0/4 auto off 0.0 n/a n/a 15.4
Gi3/0/5 auto off 0.0 n/a n/a 15.4
Gi3/0/6 auto off 0.0 n/a n/a 15.4
Gi3/0/7 auto off 0.0 n/a n/a 15.4
Gi3/0/8 auto off 0.0 n/a n/a 15.4
Gi3/0/9 auto off 0.0 n/a n/a 15.4
Gi3/0/10 auto off 0.0 n/a n/a 15.4
<output truncated>
Table 8: show power inline Field Descriptions
DescriptionField
The total amount of configured power
1
on the PoE
switch in watts (W).
Available
The amount of configured power that is allocated to
PoE ports in watts.
Used
The amount of configured power in watts that is not
allocated to ports in the system. (Available – Used =
Remaining)
Remaining
Administration mode: auto, off, static.Admin
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
116
show power inline
To Next Page
Loading...
Need help?
General
