Cisco Catalyst 3650 Series

show platform software fed switch qos
To display device-specific software information, use the show platform hardware fed switch switch_number
command.
This topic elaborates only the QoS-specific options available with the show platform software fed switch
{switch_num | active | standby } qos command.
show platform software fed switch{switch number| active| standby}qos{avc | internal| label2qmap| nflqos|
policer| policy| qsb| tablemap}
Syntax Description
The device for which you want to display information.
• switch_num—Enter the switch ID. Displays information for the specified switch.
• active—Displays information for the active switch.
• standby—Displays information for the standby switch, if available.
switch
{switch_num |
active | standby }
Displays QoS software information. Choose one the following options:
• avc —Displays Application Visibility and Control (AVC) QoS information.
• internal—Displays internal queue-related information.
• label2qmap—Displays label to queue map table information.
• nflqos—Displays NetFlow QoS information.
• policer—Displays QoS policer information in hardware.
• policy—Displays QoS policy information.
• qsb—Displays QoS sub-block information.
• tablemap—Displays table mapping information for QoS egress and ingress queues.
qos
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.1.1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
672
show platform software fed switch qos