Cisco Catalyst 3650 Series User Manual

fabric auto
To enable automatic fabric provisioning and enter automatic fabric configuration mode, use the fabric auto
command in global configuration mode.
fabric auto
Syntax Description
Enables automatic fabric provisioning and enters fabric-auto configuration
mode.
fabric auto
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
The fabric auto command allows you to configure all the elements in your fabric domain automatically.
Additionally, this command enables the auto-generation LISP, VLAN, VRF configuration, to orchestrate the
fabric overlay. The show-running configuration command shows the fabric domain configuration including
the and auto-generated base line commands.
Examples
Device(config)#fabric auto
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
19
fabric auto

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)