show stack-power
To display information about StackPower stacks or switches in a power stack, use the show stack-power
command in EXEC mode.
{show stack-power [budgeting| detail| load-shedding| neighbors] [order power-stack-name]| [stack-name
[ stack-id ]| switch [ switch-id ]]}
Syntax Description
(Optional) Displays the stack power budget table.budgeting
(Optional) Displays the stack power stack details.detail
(Optional) Displays the stack power load shedding table.load-shedding
(Optional) Displays the stack power neighbor table.neighbors
(Optional) Displays the load shedding priority for a power stack.
This keyword is available only after the load-shedding
keyword.
Note
order power-stack-name
(Optional) Displays budget table, details, or neighbors for all power stacks or
the specified power stack.
This keyword is not available after the load-shedding
keyword.
Note
stack-name
(Optional) Power stack ID for the power stack. The stack ID must be 31
characters or less.
stack-id
(Optional) Displays budget table, details, load-shedding, or neighbors for all
switches or the specified switch.
switch
(Optional) Switch ID for the switch. The switch number is from 1 to 9.
switch-id
Command Modes
Privileged EXEC
Command History
ModificationRelease
Support for all the options was
enabled for this command.
Cisco IOS XE Denali 16.3.2
This command was reintroduced.Cisco IOS XE Denali 16.1.1
Usage Guidelines
This command is available only on switch stacks running the IP Base or IP Services image.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
121
show stack-power
To Next Page
Loading...
Need help?
General
