• no—Negates a command or returns to default settings.
• power-priority—Sets the power priority for the switch and the switch ports. See the power-priority
command.
• stack-id name—Enters the name of the power stack to which the switch belongs. If you do not enter
the power stack-ID, the switch does not inherit the stack parameters. The name can be up to 31 characters.
• standalone—Forces the switch to operate in standalone power mode. This mode shuts down both stack
power ports.
Examples
This example removes switch 2, which is connected to the power stack, from the power pool and shutting
down both power ports:
Device(config)# stack-power switch 2
Device(config-switch-stackpower)# standalone
Device(config-switch-stackpower)# exit
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
129
stack-power
To Next Page
Loading...
