Usage Guidelines
For information about when to use these forwarding methods, see the Layer 2/3 Configuration Guide (Catalyst
3650 Switches) for this release.
You can verify your setting by entering the show running-config privileged EXEC command or the show
etherchannel load-balance privileged EXEC command.
Examples
This example shows how to set the extended load-distribution method:
Device(config)# port-channel load-balance extended dst-ip dst-mac src-ip
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
323
port-channel load-balance extended
To Next Page
Loading...
