Cisco Catalyst 3650 Series User Manual

debug autonomic
To enable debugging of autonomic information, use the debug autonomic command in privileged EXEC
mode. To stop the debugging, use the no form of this command.
debug autonomic {Bootstrap| Channel-Discovery| Infra| Intent| Neighbor-Discovery| Registrar| Services}
{aaa| all| database| events| ntp| packets} {info| moderate| severe}
no debug autonomic {Bootstrap| Channel-Discovery| Infra| Intent| Neighbor-Discovery| Registrar|
Services} {aaa| all| database| events| ntp| packets} {info| moderate| severe}
Syntax Description
Enables debugging of bootstrapping information.bootstrap
Enables debugging of channel discovery informationChannel-Discovery
Enables debugging of infra information.Infra
Enables debugging of intent information.Intent
Enables debugging of neighbor information.Neighbor-Discovery
Enables debugging of registrar information.Registrar
Enables debugging of autonomic services information.Services
Enables debugging authentication, authorization, and accounting
information.
aaa
Enables all debugging.all
Provides information about autonomic events.events
Enables debugging of Network Time Protocol (NTP) information.ntp
Provides information about autonomic packets.packets
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
Use this command to debug the autonomic networking information.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
892
debug autonomic

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)