Cisco Catalyst 3650 Series

net6-dhcp
To initiate an IPv6 Dynamic Host Control Protocol (DHCP) request for remote configuration, use the net6-dhcp
command in rommon mode.
net6-dhcp [timeout]
Syntax Description
(Optional) Timeout in seconds.timeout
Command Modes
Rommon
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Everest 16.5.1
Usage Guidelines
You can change the timeout by specifying a time in seconds
Examples
The following example shows how to enable the net6-dhcp command:
Device: net6-dhcp
Related Commands
DescriptionCommand
Displays or changes the network debug values.net-debug
Initiates an IPv4 DHCP request and processes
the reply.
net-dhcp
Displays network parameters.net-show
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
589
net6-dhcp