snmp-server enable traps mac-notification
To enable SNMP MAC notification traps, use the snmp-server enable traps mac-notification command in
global configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps mac-notification [change][move][threshold]
no snmp-server enable traps mac-notification [change][move][threshold]
Syntax Description
(Optional) Enables SNMP MAC change traps.change
(Optional) Enables SNMP MAC move traps.move
(Optional) Enables SNMP MAC threshold traps.threshold
Command Default
The sending of SNMP MAC notification traps is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples
This example shows how to generate SNMP MAC notification change traps:
Device(config)# snmp-server enable traps mac-notification change
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
545
snmp-server enable traps mac-notification