The following syslog message appears when a PIM tunnel interface is created:
* %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel<interface_number>,
changed state to up
Examples
The following is sample output from the show ip pim tunnel taken from an RP. The output is used to verify
the PIM Encap and Decap Tunnel on the RP:
Device# show ip pim tunnel
Tunnel0
Type : PIM Encap
RP : 70.70.70.1*
Source: 70.70.70.1
Tunnel1*
Type : PIM Decap
RP : 70.70.70.1*
Source: -R2#
The asterisk (*) indicates that the router is the RP. The RP will always have a PIM Encap and Decap
Tunnel interface.
Note
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
264
show ip pim tunnel
To Next Page
Loading...
