interface
To configure an interface, use the interface command.
interface {Auto-Template Auto-Template interface-number | GigabitEthernet Gigabit Ethernet interface
number | Group VI Group VI interface number Internal Interface Internal Interface number Loopback
Loopback interface number Null Null interface number Port-channel interface number Port-channel
interface number TenGigabitEthernet interface number Tunnel interface number Vlan interface number
}
Syntax Description
Enables you to configure a auto-template interface. The range
is 1 to 999.
Auto-Template Auto-template
interface-number
Enables you to configure a Gigabit Ethernet IEEE 802.3z
interface. The range is from 0 to 9.
GigabitEthernet Gigabit Ethernet interface
number
Enables you to configure a Group VI interface. The range is
from 0 to 9.
Group VI Group VI interface number
Enables you to configure an internal interface.Internal Interface Internal Interface
Enables you to configure a loopback interface. The range is
from 0 to 2147483647.
Loopback Loopback Interface number
Enables you to configure a null interface. The default value is
0.
Null Null interface number
Enables you to configure a port-channel interface. The range
is from 1 to 128.
Port-channel interface number
Enables you to configure a 10-Gigabit Ethernet interface. The
range is from 0 to 9.
TenGigabitEthernet interface number
Enables you to configure a tunnel interface. The range is from
0 to 2147483647.
Tunnel interface number
Enables you to configure a switch VLAN. The range is from 0
to 4098.
Vlan interface number
Command Default
None
Command Modes
Global configuration
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
42
interface
To Next Page
Loading...
Need help?
General
