Cisco Catalyst 3650 Series

net-dhcp
To initiate an IPv4 Dynamic Host Control Protocol (DHCP) request for remote configuration, use the net-dhcp
command in rommon mode.
net-dhcp [timeout]
Syntax Description
(Optional) Timeout in seconds.timeout
Command Modes
Rommon
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Everest 16.5.1
Usage Guidelines
This command initiates an IPv4 DHCP request and processes the reply.
Examples
The following example shows how to enable the net-dhcp command:
Device: net-dhcp
Related Commands
DescriptionCommand
Displays or changes the network debug values.net-debug
Displays network parameters.net-show
Initiates an IPv6 DHCP request for remote
configuration.
net6-dhcp
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
588
net-dhcp