show auto qos
To display the quality of service (QoS) commands entered on the interfaces on which automatic QoS (auto-QoS)
is enabled, use the show auto qos command in privileged EXEC mode.
show auto qos [interface [ interface-id ]]
Syntax Description
(Optional) Displays auto-QoS information for the specified port or for all
ports. Valid interfaces include physical ports.
interface [interface-id]
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
The show auto qos command output shows only the auto qos command entered on each interface. The show
auto qos interface interface-id command output shows the auto qos command entered on a specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the user
modifications.
Beginning in Cisco IOS Release 12.2(40)SE, the show auto qos command output shows the service policy
information for the Cisco IP phone.
Examples
This is an example of output from the show auto qos command after the auto qos voip cisco-phone and the
auto qos voip cisco-softphone interface configuration commands are entered:
Device# show auto qos
GigabitEthernet2/0/4
auto qos voip cisco-softphone
GigabitEthernet2/0/5
auto qos voip cisco-phone
GigabitEthernet2/0/6
auto qos voip cisco-phone
This is an example of output from the show auto qos interface interface-id command when the auto qos
voip cisco-phone interface configuration command is entered:
Device# show auto qos interface gigabitethernet 2/0/5
GigabitEthernet2/0/5
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
638
show auto qos
To Next Page
Loading...
Need help?
General
