Cisco Catalyst 3650 Series

(Optional) Specifies EtherType 0x6000.etype-6000
(Optional) Specifies EtherType 0x8042.etype-8042
(Optional) Specifies EtherType DEC-LAT.lat
(Optional) Specifies EtherType DEC-LAVC-SCA.lavc-sca
(Optional) Specifies the LSAP number (0 to 65535) of a packet
with 802.2 encapsulation to identify the protocol of the packet.
The mask is a mask of don’t care bits applied to the LSAP number
before testing for a match.
lsap lsap-number mask
(Optional) Specifies EtherType DEC-MOP Remote Console.mop-console
(Optional) Specifies EtherType DEC-MOP Dump.mop-dump
(Optional) Specifies EtherType DEC-MSDOS.msdos
(Optional) Specifies EtherType DEC-MUMPS.mumps
(Optional) Specifies EtherType DEC- Network Basic Input/Output
System (NetBIOS).
netbios
(Optional) Specifies EtherType Virtual Integrated Network Service
(VINES) Echo from Banyan Systems.
vines-echo
(Optional) Specifies EtherType VINES IP.vines-ip
(Optional) Specifies EtherType Xerox Network Systems (XNS)
protocol suite.
xns-idp
(Optional) Specifies an arbitrary class of service (CoS) number
from 0 to 7 to set priority. Filtering on CoS can be performed only
in hardware. A warning message appears if the cos option is
configured.
cos cos
Command Default
This command has no defaults. However, the default action for a MAC-named ACL is to deny.
Command Modes
Mac-access list configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
790
permit (MAC access-list configuration)