Cisco Catalyst 3650 Series User Manual

port-channel auto
To enable the auto-LAG feature on a switch globally, use the port-channel auto command in global
configuration mode. To disable the auto-LAG feature on the switch globally, use no form of this command.
port-channel auto
no port-channel auto
Syntax Description
This command has no arguments or keywords.
Command Default
By default, the auto-LAG feature is disabled globally and is enabled on all port interfaces.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.7.2E
Usage Guidelines
You can use the show etherchannel auto privileged EXEC command to verify if the EtherChannel was
created automatically.
Examples
This example shows how to enable the auto-LAG feature on the switch:
Device(config)# port-channel auto
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
319
port-channel auto

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)