Cisco Catalyst 3650 Series User Manual

power inline police
To enable policing of real-time power consumption on a powered device, use the power inline police command
in interface configuration mode. To disable this feature, use the no form of this command
power inline police [action {errdisable| log}]
no power inline police
Syntax Description
(Optional) Configures the device to turn off power to the port if the real-time power
consumption exceeds the maximum power allocation on the port. This is the default
action.
action errdisable
(Optional) Configures the device to generate a syslog message while still providing
power to a connected device if the real-time power consumption exceeds the
maximum power allocation on the port.
action log
Command Default
Policing of the real-time power consumption of the powered device is disabled.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
This command is supported only on the LAN Base image.
This command is supported only on Power over Ethernet (PoE)-capable ports. If you enter this command on
a device or port that does not support PoE, an error message appears.
In a switch stack, this command is supported on all switches or ports in the stack that support PoE and real-time
power-consumption monitoring.
When policing of the real-time power consumption is enabled, the device takes action when a powered device
consumes more power than the allocated maximum amount.
When PoE is enabled, the device senses the real-time power consumption of the powered device. This feature
is called power monitoring or power sensing. The device also polices the power usage with the power policing
feature.
When power policing is enabled, the device uses one of the these values as the cutoff power on the PoE port
in this order:
1
The user-defined power level that limits the power allowed on the port when you enter the power inline
auto max max-wattage or the power inline static max max-wattage interface configuration command
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
63
power inline police

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)