Cisco Catalyst 3650 Series User Manual

transport
To configure the transport protocol for a flow exporter for Flexible NetFlow, use the transport command in
flow exporter configuration mode. To remove the transport protocol for a flow exporter, use the no form of
this command.
transport udp udp-port
no transport udp udp-port
Syntax Description
Specifies User Datagram Protocol (UDP) as the transport protocol and the
UDP port number.
udp udp-port
Command Default
Flow exporters use UDP on port 9995.
Command Modes
Flow exporter configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
To return this command to its default settings, use the no transport or default transport flow exporter
configuration command.
Examples
The following example configures UDP as the transport protocol and a UDP port number of 250:
Device(config)# flow exporter FLOW-EXPORTER-1
Device(config-flow-exporter)# transport udp 250
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
477
transport

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)