Cisco Catalyst 3650 Series

Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----------+----------------------------------------
1 Po1(SU) LACP Gi1/0/1(P) Gi1/0/2(P)
This is an example of output from the show etherchannel channel-group-number port-channel command:
Device> show etherchannel 1 port-channel
Port-channels in the group:
----------------------
Port-channel: Po1 (Primary Aggregator)
------------
Age of the Port-channel = 01d:20h:24m:50s
Logical slot/port = 10/1 Number of ports = 2
Logical slot/port = 10/1 Number of ports = 2
Port state = Port-channel Ag-Inuse
Protocol = LACP
Ports in the Port-channel:
Index Load Port EC state No of bits
------+------+------+------------------+-----------
0 00 Gi1/0/1 Active 0
0 00 Gi1/0/2 Active 0
Time since last port bundled: 01d:20h:24m:44s Gi1/0/2
This is an example of output from show etherchannel protocol command:
Device# show etherchannel protocol
Channel-group listing:
-----------------------
Group: 1
----------
Protocol: LACP
Group: 2
----------
Protocol: PAgP
Related Commands
DescriptionCommand
Assigns an Ethernet port to an EtherChannel group, or enables an
EtherChannel mode, or both.
channel-group
Restricts the protocol used on a port to manage channeling.
channel-protocol
Accesses or creates a port channel.
interface port-channel
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
338
show etherchannel