Cisco Catalyst 3650 Series

redundancy reload
To force a reload of one or all of the switches in the stack, use the redundancy reload command in privileged
EXEC mode.
redundancy reload {peer| shelf}
Syntax Description
Reloads the peer unit.peer
Reboots all switches in the stack.shelf
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Before using this command, see the “Performing a Software Upgrade” section of the Stacking Configuration
Guide (Catalyst 3650 Switches) for additional information.
Use the redundancy reload shelf command to reboot all the switches in the stack.
Examples
This example shows how to manually reload all switches in the stack:
Device# redundancy reload shelf
Device#
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
860
redundancy reload