Cisco Catalyst 3650 Series

Examples
In the following example, if a packet is sent to 10.255.255.255, it is replicated to destinations 10.0.0.1 and
10.0.0.2:
Switch(config)# interface tunnel 0
Switch(config-if)# ip address 10.0.0.3 255.0.0.0
Switch(config-if)# ip nhrp map multicast 10.0.0.1
Switch(config-if)# ip nhrp map multicast 10.0.0.2
Related Commands
DescriptionCommand
Enables NHRP debugging.debug nhrp
Configures an interface and enters interface
configuration mode.
interface
Specifies the destination for a tunnel interface.tunnel destination
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
178
ip nhrp map multicast