glbp name
To enable IP redundancy by assigning a name to the Gateway Load Balancing Protocol (GLBP) group, use
the glbp name command in interface configuration mode. To disable IP redundancy for a group, use the no
form of this command.
glbp group-number name group-name
no glbp group-number name group-name
Syntax Description
GLBP group number. Range is from 0 to 1023.
group-number
GLBP group name specified as a character string.
Maximum number of characters is 255.
group-name
Command Default
IP redundancy for a group is disabled.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced..Cisco IOS XE Release 2.1
Usage Guidelines
The GLBP redundancy client must be configured with the same GLBP group name so that the redundancy
client and the GLBP group can be connected.
Examples
The following example assigns the abccomp name to GLBP group 10:
Device(config-if)# glbp 10 name abccomp
Related Commands
DescriptionCommand
Configures an authentication string for the GLBP.glbp authentication
Configures a device to take over as AVF for a GLBP
group if it has higher priority than the current AVF.
glbp forwarder preempt
Activates GLBP.glbp ip
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
156
glbp name
To Next Page
Loading...
Need help?
General
