Cisco Catalyst 3650 Series

mpls label protocol (global configuration)
To specify the Label Distribution Protocol (LDP) for a platform, use the mpls label protocol command in
global configuration mode. To restore the default LDP, use the no form of this command.
mpls label protocol ldp
no mpls label protocol ldp
Syntax Description
Specifies that LDP is the default label distribution
protocol.
ldp
Command Default
LDP is the default label distribution protocol.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
If neither the global mpls label protocol ldp command nor the interface mpls label protocol ldp command is
used, all label distribution sessions use LDP.
Examples
The following command establishes LDP as the label distribution protocol for the platform:
Switch(config)# mpls label protocol ldp
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
379
mpls label protocol (global configuration)