Cisco Catalyst 3650 Series User Manual

debug ilpower
To enable debugging of the power controller and Power over Ethernet (PoE) system, use the debug ilpower
command in privileged EXEC mode. To disable debugging, use the no form of this command.
debug ilpower {cdp| event| ha| ipc| police| port| powerman| registries| scp | sense| upoe}
no debug ilpower {cdp| event| ha| ipc| police| port| powerman| registries| scp | sense| upoe}
Syntax Description
Displays PoE Cisco Discovery Protocol (CDP) debug messages.cdp
Displays PoE event debug messages.event
Displays PoE high-availability messages.ha
Displays PoE Inter-Process Communication (IPC) debug messages.ipc
Displays PoE police debug messages.police
Displays PoE port manager debug messages.port
Displays PoE power management debug messages.powerman
Displays PoE registries debug messages.registries
Displays PoE SCP debug messages.scp
Displays PoE sense debug messages.sense
Displays Cisco UPOE debug messages.upoe
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
This command is supported only on PoE-capable switches.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
29
debug ilpower

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)