Cisco Catalyst 3650 Series User Manual

rep lsl-retries
To configure the REP link status layer (LSL) number of retries, use the rep lsl-retries command in interface
configuration mode. To restore the default number of retries, use the no form of this command.
rep lsl-retries number-of-retries
no rep lsl-retries number-of-retries
Syntax Description
Number of LSL retries. The range of retries is from 3 to 10.
number-of-retries
Command Default
The default number of LSL retries is 5.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introducedCisco IOS XE Denali 16.2.2
Usage Guidelines
The rep lsl-retries command is used to configure the number of retries before the REP link is disabled. While
configuring REP configurable timers, we recommend that you configure the REP LSL number of retries first
and then configure the REP LSL age-out timer value.
Examples
The following example shows how to configure REP LSL retries.
Device(config)# interface TenGigabitEthernet 4/1
Device(config-if)# rep segment 2 edge primary
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
330
rep lsl-retries

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)