Cisco Catalyst 3650 Series User Manual

snmp-server enable traps cef
To enable SNMP Cisco Express Forwarding (CEF) traps, use the snmp-server enable traps cef command
in global configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps cef [inconsistency | peer-fib-state-change | peer-state-change | resource-failure]
no snmp-server enable traps cef [inconsistency | peer-fib-state-change | peer-state-change |
resource-failure]
Syntax Description
(Optional) Enables SNMP CEF Inconsistency traps.inconsistency
(Optional) Enables SNMP CEF Peer FIB State change traps.peer-fib-state-change
(Optional) Enables SNMP CEF Peer state change traps.peer-state-change
(Optional) Enables SNMP CEF Resource Failure traps.resource-failure
Command Default
The sending of SNMP CEF traps is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples
This example shows how to generate SNMP CEF inconsistency traps:
Device(config)# snmp-server enable traps cef inconsistency
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
538
snmp-server enable traps cef

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)