Cisco Catalyst 3650 Series

show ip pim autorp
To display global information about auto-rp, use the show ip pim autorp command in privileged EXEC
mode.
show ip pim autorp
Syntax Description
This command has no arguments or keywords.
Command Default
auto-rp is enabled by default.
Command Modes
Privileged EXEC mode
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
This command displays whether auto-rp is enabled or disabled.
Examples
The following command output displays that auto-rp is enabled:
Device# show ip pim autorp
AutoRP Information:
AutoRP is enabled.
RP Discovery packet MTU is 0.
224.0.1.40 is joined on GigabitEthernet1/0/1.
PIM AutoRP Statistics: Sent/Received
RP Announce: 0/0, RP Discovery: 0/0
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
260
show ip pim autorp