Cisco Catalyst 3650 Series User Manual

show ip pim mdt send
To display the data multicast distribution tree (MDT) groups in use, use the show ip pim mdt send command
in privileged EXEC mode.
show ip pim vrf vrf-name mdt send
Syntax Description
Displays the data MDT groups in use by the Multicast
VPN (MVPN) routing and forwarding (MVRF)
instance specified for the vrf-name argument.
vrf vrf-name
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.2
Usage Guidelines
Use this command to show the data MDT groups in use by a specified MVRF.
Examples
The following is sample output from the show ip pim mdt send command:
Device# show ip pim vrf vpn8 mdt send
MDT-data send list for VRF:vpn8
(source, group) MDT-data group ref_count
(10.100.8.10, 225.1.8.1) 232.2.8.0 1
(10.100.8.10, 225.1.8.2) 232.2.8.1 1
(10.100.8.10, 225.1.8.3) 232.2.8.2 1
(10.100.8.10, 225.1.8.4) 232.2.8.3 1
(10.100.8.10, 225.1.8.5) 232.2.8.4 1
(10.100.8.10, 225.1.8.6) 232.2.8.5 1
(10.100.8.10, 225.1.8.7) 232.2.8.6 1
(10.100.8.10, 225.1.8.8) 232.2.8.7 1
(10.100.8.10, 225.1.8.9) 232.2.8.8 1
(10.100.8.10, 225.1.8.10) 232.2.8.9 1
The table below describes the significant fields shown in the display.
Table 22: show ip pim mdt send Field Descriptions
DescriptionField
Source and group addresses that this router has
switched over to data MDTs.
source, group
Multicast address over which these data MDTs are
being sent.
MDT-data group
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
400
show ip pim mdt send

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)