DescriptionField
Operating mode:
• on—The powered device is detected, and power
is applied.
• off—No PoE is applied.
• faulty—Device detection or a powered device
is in a faulty state.
• power-deny—A powered device is detected,
but no PoE is available, or the maximum
wattage exceeds the detected powered-device
maximum.
Oper
The maximum amount of power that is allocated to
the powered device in watts. This value is the same
as the value in the Cutoff Power field in the show
power inline police command output.
Power
The device type detected: n/a, unknown, Cisco
powered-device, IEEE powered-device, or the name
from CDP.
Device
The IEEE classification: n/a or a value from 0 to 4.Class
The maximum amount of power allocated to the
powered device in watts.
Max
The maximum amount power allocated to the powered
device in watts when the switch polices the real-time
power consumption. This value is the same as the
Max field value.
AdminPowerMax
The power consumption of the powered device in
watts when the switch polices the real-time power
consumption. If policing is disabled, this value is the
same as the AdminPowerMax field value.
AdminConsumption
1
The configured power is the power that you manually specify or that the switch specifies by using CDP power negotiation or the IEEE classification, which
is different than the real-time power that is monitored with the power sensing feature.
This is an example of output from the show power inline police command on a stacking-capable switch:
Device> show power inline police
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 370.0 0.0 370.0
3 865.0 864.0 1.0
Admin Oper Admin Oper Cutoff Oper
Interface State State Police Police Power Power
--------- ------ ----------- ---------- ---------- ------ ------
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
117
show power inline
To Next Page
Loading...
Need help?
General
