Cisco Catalyst 3650 Series User Manual

fhrp delay
To specify the delay period for the initialization of First Hop Redundancy Protocol (FHRP) clients, use the
fhrp delay command in interface configuration mode. To remove the delay period specified, use the no form
of this command.
fhrp delay {[minimum] [reload] seconds}
no fhrp delay {[minimum] [reload] seconds}
Syntax Description
(Optional) Configures the delay period after an
interface becomes available.
minimum
(Optional) Configures the delay period after the
device reloads.
reload
Delay period in seconds. The range is from 0 to 3600.
seconds
Command Default
None
Command Modes
Interface configuration (config-if)
Examples
This example shows how to specify the delay period for the initialization of FHRP clients:
Device(config-if)# fhrp delay minimum 90
Related Commands
DescriptionCommand
Displays First Hop Redundancy Protocol (FHRP)
information.
show fhrp
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
147
fhrp delay

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)