Cisco Catalyst 3650 Series User Manual

debug sampler
To enable debugging output for Flexible NetFlow samplers, use the debug sampler command in privileged
EXEC mode. To disable debugging output, use the no form of this command.
debug sampler [detailed| error| [name] sampler-name [detailed| error| sampling samples]]
no debug sampler [detailed| error| [name] sampler-name [detailed| error| sampling]]
Syntax Description
(Optional) Enables detailed debugging for sampler elements.detailed
(Optional) Enables debugging for sampler errors.error
(Optional) Specifies the name of a sampler.name
(Optional) Name of a sampler that was previously configured.
sampler-name
(Optional) Enables debugging for sampling and specifies the number of
samples to debug.
sampling samples
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
The following sample output shows that the debug process has obtained the ID for the sampler named
SAMPLER-1:
Device# debug sampler detailed
*May 28 04:14:30.883: Sampler: Sampler(SAMPLER-1: flow monitor FLOW-MONITOR-1 (ip,Et1/0,O)
get ID succeeded:1
*May 28 04:14:30.971: Sampler: Sampler(SAMPLER-1: flow monitor FLOW-MONITOR-1 (ip,Et0/0,I)
get ID succeeded:1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
423
debug sampler

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)