flash_init
To initialize the flash: file system, use the flash_init command in boot loader mode.
flash_init
Syntax Description
This command has no arguments or keywords.
Command Default
The flash: file system is automatically initialized during normal system operation.
Command Modes
Boot loader
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
During the normal boot process, the flash: file system is automatically initialized.
Use this command to manually initialize the flash: file system. For example, you use this command during
the recovery procedure for a lost or forgotten password.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
921
flash_init
To Next Page
Loading...
