Examples
The following example shows how to configure the switch to advertise itself as a C-RP to the BSR in its PIM
domain. The standard access list number 4 specifies the group prefix associated with the RP that has the
address identified by Gigabit Ethernet interface 1/0/1.
Device(config)# ip pim rp-candidate GigabitEthernet1/0/1 group-list 4
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
236
ip pim rp-candidate
To Next Page
Loading...
