Cisco Catalyst 3650 Series

vrrp
To create a Virtual Router Redundancy Protocol version 3 (VRRPv3) group and enter VRRPv3 group
configuration mode, use the vrrp. To remove the VRRPv3 group, use the no form of this command.
vrrp group-id address-family {ipv4 | ipv6}
no vrrp group-id address-family {ipv4 | ipv6}
Syntax Description
Virtual router group number. The range is from 1 to
255.
group-id
Specifies the address-family for this VRRP group.address-family
(Optional) Specifies IPv4 address.ipv4
(Optional) Specifies IPv6 address.ipv6
Command Default
None
Command Modes
Interface configuration (config-if)
Usage Guidelines
Examples
The following example shows how to create a VRRPv3 group and enter VRRP configuration mode:
Device(config-if)# vrrp 3 address-family ipv4
Related Commands
DescriptionCommand
Sets the advertisement timer in milliseconds.timers advertise
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
201
vrrp