Cisco Catalyst 3650 Series User Manual

dot1x critical (global configuration)
To configure the IEEE 802.1X critical authentication parameters, use the dot1x critical command in global
configuration mode.
dot1x critical eapol
Syntax Description
Specifies that the switch send an EAPOL-Success message when the switch
successfully authenticates the critical port.
eapol
Command Default
eapol is disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Examples
This example shows how to specify that the switch sends an EAPOL-Success message when the switch
successfully authenticates the critical port:
Device(config)# dot1x critical eapol
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
747
dot1x critical (global configuration)

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)