debug platform poe
To enable debugging of a Power over Ethernet (PoE) port, use the debug platform poe command in privileged
EXEC mode. To disable debugging, use the no form of this command.
debug platform poe [error| info] [switch switch-number]
no debug platform poe [error| info] [switch switch-number]
Syntax Description
(Optional) Displays PoE-related error debug messages.error
(Optional) Displays PoE-related information debug messages.info
(Optional) Specifies the stack member. This keyword is supported only on
stacking-capable switches.
switch switch-number
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
The undebug platform poe command is the same as the no debug platform poe command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
33
debug platform poe
To Next Page
Loading...
