Cisco Catalyst 3650 Series User Manual

show vlan filter
To display information about all VLAN filters or about a particular VLAN or VLAN access map, use the
show vlan filter command in privileged EXEC mode.
show vlan filter {access-map name| vlan vlan-id}
Syntax Description
(Optional) Displays filtering information for the specified VLAN access
map.
access-map name
(Optional) Displays filtering information for the specified VLAN. The
range is 1 to 4094.
vlan vlan-id
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Examples
This is an example of output from the show vlan filter command:
Device# show vlan filter
VLAN Map map_1 is filtering VLANs:
20-22
Related Commands
DescriptionCommand
Displays the VLAN access maps created on the switch.
show vlan access-map
Defines a VLAN map and enters access-map configuration mode where
you can specify a MAC ACL to match and the action to be taken.
vlan access-map
Applies a VLAN map to one or more VLANs.
vlan filter
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
826
show vlan filter

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)