Cisco Catalyst 3650 Series User Manual

service-routing mdns-sd
To enable mDNS gateway functionality for a device and enter multicast DNS configuration mode, use the
service-routing mdns-sd command. To restore default settings and return to global config mode, enter the
no form of the command.
service-routing mdns-sd
no service-routing mdns-sd
This command has no arguments or keywords.
Command Default
Disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
mDNS gateway functionality can only be enabled or disabled globally, not on a per-interface basis. The service
filter policy and redistribution can be configured globally as well as on a per-interface basis. Any interface
specific configuration overrides the global configuration.
Examples
This example shows how to enable mDNS gateway functionality for a device and enter multicast DNS
configuration mode:
Device(config)# service-routing mdns-sd
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
249
service-routing mdns-sd

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)