Cisco Catalyst 3650 Series

policy config-sync prc reload
To reload the standby switch if a parser return code (PRC) failure occurs during configuration synchronization,
use the policy config-sync reload command in redundancy configuration mode. To specify that the standby
switch is not reloaded if a parser return code (PRC) failure occurs, use the no form of this command.
policy config-sync {bulk| lbl} prc reload
no policy config-sync {bulk| lbl} prc reload
Syntax Description
Specifies bulk configuration mode.bulk
Specifies line-by-line (lbl) configuration mode.lbl
Command Default
The command is enabled by default.
Command Modes
Redundancy configuration (config-red)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Examples
This example shows how to specify that the standby switch is not reloaded if a parser return code (PRC)
failure occurs during configuration synchronization:
Device(config-red)# no policy config-sync bulk prc reload
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
855
policy config-sync prc reload