Cisco Catalyst 3650 Series

show etherchannel
To display EtherChannel information for a channel, use the show etherchannel command in user EXEC
mode.
show etherchannel [channel-group-number | {detail | port | port-channel | protocol | summary }] | [auto|
detail| load-balance | port| port-channel| protocol| summary]
Syntax Description
(Optional) Channel group number. The range is 1 to 128.
channel-group-number
(Optional) Displays that Etherchannel is created
automatically.
auto
(Optional) Displays detailed EtherChannel information.detail
(Optional) Displays the load-balance or frame-distribution
scheme among ports in the port channel.
load-balance
(Optional) Displays EtherChannel port information.port
(Optional) Displays port-channel information.port-channel
(Optional) Displays the protocol that is being used in the
channel.
protocol
(Optional) Displays a one-line summary per channel group.summary
Command Default
None
Command Modes
User EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
If you do not specify a channel group number, all channel groups are displayed.
Examples
This is an example of output from the show etherchannel auto command:
device# show etherchannel auto
Flags: D - down P - bundled in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
336
show etherchannel