Cisco Catalyst 3650 Series User Manual

(Optional) Enables SNMP FLASH notification traps.*flash
(Optional) Generates entity field-replaceable unit (FRU) control
traps. In a device stack, this trap refers to the insertion or removal of
a device in the stack.
fru-ctrl
(Optional) Enables license traps.*license
(Optional) Enables SNMP MAC Notification traps.*mac-notification
(Optional) Enables SNMP port security traps.*port-security
(Optional) Enables SNMP power Ethernet traps.*power-ethernet
(Optional) Enables SNMP Resilient Ethernet Protocol traps.rep
(Optional) Enables SNMP traps.*snmp
(Optional) Enables SNMP stackwise traps.*stackwise
(Optional) Enables SNMP storm-control trap parameters.*storm-control
(Optional) Enables SNMP STPX MIB traps.*stpx
(Optional) Enables SNMP syslog traps.syslog
(Optional) Enables SNMP transceiver traps.*transceiver
(Optional) Sends TCP connection traps. This is enabled by default.tty
(Optional) Enables SNMP VLAN membership traps.vlan-membership
(Optional) Enables SNMP VLAN-created traps.vlancreate
(Optional) Enables SNMP VLAN-deleted traps.vlandelete
(Optional) Enables SNMP Smart Install traps.*vstack
(Optional) Enables VLAN Trunking Protocol (VTP) traps.vtp
Command Default
The sending of SNMP traps is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
532
snmp-server enable traps

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)