Cisco Catalyst 3650 Series User Manual

show storm-control
To display broadcast, multicast, or unicast storm control settings on the switch or on the specified interface
or to display storm-control history, use the show storm-control command in user EXEC mode.
show storm-control [interface-id] [broadcast| multicast| unicast]
Syntax Description
(Optional) Interface ID for the physical port (including type, stack member
for stacking-capable switches, module, and port number).
interface-id
(Optional) Displays broadcast storm threshold setting.broadcast
(Optional) Displays multicast storm threshold setting.multicast
(Optional) Displays unicast storm threshold setting.unicast
Command Modes
User EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
When you enter an interface ID, the storm control thresholds appear for the specified interface.
If you do not enter an interface ID, settings appear for one traffic type for all ports on the switch.
If you do not enter a traffic type, settings appear for broadcast storm control.
Examples
This is an example of a partial output from the show storm-control command when no keywords are entered.
Because no traffic-type keyword was entered, the broadcast storm control settings appear.
Device> show storm-control
Interface Filter State Upper Lower Current
--------- ------------- ---------- --------- ---------
Gi1/0/1 Forwarding 20 pps 10 pps 5 pps
Gi1/0/2 Forwarding 50.00% 40.00% 0.00%
<output truncated>
This is an example of output from the show storm-control command for a specified interface. Because no
traffic-type keyword was entered, the broadcast storm control settings appear.
Device> show storm-control gigabitethernet 1/0/1
Interface Filter State Upper Lower Current
--------- ------------- ---------- --------- ---------
Gi1/0/1 Forwarding 20 pps 10 pps 5 pps
The following table describes the fields in the show storm-control display:
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
823
show storm-control

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)