vrrp timers advertise
To configure the interval between successive advertisements by the master virtual router in a Virtual Router
Redundancy Protocol (VRRP) group, use the timers advertise command in VRRP configuration mode. To
restore the default value, use the no form of this command.
timers advertise [msec] interval
no timers advertise [msec] interval
Syntax Description
Virtual router group number. The group number range
is from 1 to 255.
group
(Optional) Changes the unit of the advertisement time
from seconds to milliseconds. Without this keyword,
the advertisement interval is in seconds.
msec
Time interval between successive advertisements by
the master virtual router. The unit of the interval is
in seconds, unless the msec keyword is specified. The
default is 1 second. The valid range is 1 to 255
seconds. When the msec keyword is specified, the
valid range is 50 to 999 milliseconds.
interval
Command Default
The default interval of 1 second is configured.
Command Modes
VRRP configuration (config-if-vrrp)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Release 2.1
Usage Guidelines
The advertisements being sent by the master virtual router communicate the state and priority of the current
master virtual router.
The vrrp timers advertise command configures the time between successive advertisement packets and the
time before other routers declare the master router to be down. Routers or access servers on which timer values
are not configured can learn timer values from the master router. The timers configured on the master router
always override any other timer settings. All routers in a VRRP group must use the same timer values. If the
same timer values are not set, the devices in the VRRP group will not communicate with each other and any
misconfigured device will change its state to master.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
206
vrrp timers advertise
To Next Page
Loading...
Need help?
General
