mode random 1 out-of
To enable random sampling and to specify the packet interval for a Flexible NetFlow sampler, use the mode
random 1 out-of command in sampler configuration mode. To remove the packet interval information for a
Flexible NetFlow sampler, use the no form of this command.
mode random 1 out-of window-size
no mode
Syntax Description
Specifies the window size from which to select packets. The range is 2 to
1024.
window-size
Command Default
The mode and the packet interval for a sampler are not configured.
Command Modes
Sampler configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A total of four unique samplers are supported on the . Packets are chosen in a manner that should eliminate
any bias from traffic patterns and counter any attempt by users to avoid monitoring.
The deterministic keyword is not supported, even though it is visible in the command-line help string.Note
Examples
The following example enables random sampling with a window size of 1000:
Device(config)# sampler SAMPLER-1
Device(config-sampler)# mode random 1 out-of 1000
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
457
mode random 1 out-of
To Next Page
Loading...
Need help?
General
