Cisco Catalyst 3650 Series User Manual

show vlan access-map
To display information about a particular VLAN access map or for all VLAN access maps, use the show vlan
access-map command in privileged EXEC mode.
show vlan access-map [map-name]
Syntax Description
(Optional) Name of a specific VLAN access map.
map-name
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Examples
This is an example of output from the show vlan access-map command:
Device# show vlan access-map
Vlan access-map "vmap4" 10
Match clauses:
ip address: al2
Action:
forward
Vlan access-map "vmap4" 20
Match clauses:
ip address: al2
Action:
forward
Related Commands
DescriptionCommand
Displays information about all VLAN filters or about a particular VLAN or
VLAN access map.
show vlan filter
Defines a VLAN map and enters access-map configuration mode where you
can specify a MAC ACL to match and the action to be taken.
vlan access-map
Applies a VLAN map to one or more VLANs.
vlan filter
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
825
show vlan access-map

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)