auto qos video
To automatically configure quality of service (QoS) for video within a QoS domain, use the auto qos video
command in interface configuration mode. Use the no form of this command to return to the default setting.
auto qos video {cts | ip-camera | media-player}
no auto qos video {cts | ip-camera | media-player}
Syntax Description
Specifies a port connected to a Cisco TelePresence System and automatically
configures QoS for video.
cts
Specifies a port connected to a Cisco IP camera and automatically configures QoS
for video.
ip-camera
Specifies a port connected to a CDP-capable Cisco digital media player and
automatically configures QoS for video.
media-player
Command Default
Auto-QoS video is disabled on the port.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use this command to configure the QoS appropriate for video traffic within the QoS domain. The QoS domain
includes the device, the network interior, and edge devices that can classify incoming traffic for QoS. When
auto-QoS is enabled, it uses the ingress packet label to categorize traffic, to assign packet labels, and to
configure the ingress and egress queues. For more information, see the queue tables at the end of this section.
Auto-QoS configures the device for video connectivity to a Cisco TelePresence system, a Cisco IP camera,
or a Cisco digital media player.
To take advantage of the auto-QoS defaults, you should enable auto-QoS before you configure other QoS
commands. You can fine-tune the auto-QoS configuration after you enable auto-QoS.
The device applies the auto-QoS-generated commands as if the commands were entered from the command-line
interface (CLI). An existing user configuration can cause the application of the generated commands to fail
or to be overridden by the generated commands. These actions occur without warning. If all the generated
commands are successfully applied, any user-entered configuration that was not overridden remains in the
running configuration. Any user-entered configuration that was overridden can be retrieved by reloading the
device without saving the current configuration to memory. If the generated commands fail to be applied, the
previous running configuration is restored.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
615
auto qos video
To Next Page
Loading...
Need help?
General
